판매가 | 19000 |
---|---|
할인판매가 | 19,000원 (19,000원 할인) |
할인금액 | 총 할인금액 원 (모바일할인금액 원) |
적립금 |
190원(1.00%) 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % |
배송방법 | 택배 |
배송비 | 3,500원 (150,000원 이상 구매 시 무료) |
배송 | |
---|---|
수량 |
상품 정보 | 가격 | 삭제 |
---|---|---|
총상품금액(수량) 0 |
상품명 | [DFR0065]FTDI 기본 브레이크 아웃 3.3/5V (아두이노 호환) FTDI Basic Breakout 3.3/5V (Arduino Compatible) 아두이노 FTDI USB to TTL 변환 보드 |
---|---|
상품요약정보 | FTDI 베이직 브레이크아웃 3.3/5V, 아두이노 호환 |
판매가 | 19,000원 |
제조사 | DFRobot |
원산지 | 해외 |
적립금 | 190원 (1%) |
상품코드 | P0000UIB |
배송방법 | 택배 |
배송비 | 3,500원 (150,000원 이상 구매 시 무료) |
수량 |
*DFRobot 제품은 해외배송 입니다
배송기간 이 약 2주 소요 됩니다
해외배송 제품은 주문 후 취소가 불가능 합니다
교환,반품,기술지원 이 불가능 합니다
구매전 이점 꼭 확인해 주세요*
This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.
The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is DTR. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.
There are pros and cons to the FTDI Cable vs the FTDI Basic. This board has TX and RX LEDs that allow you to actually see serial traffic on the LEDs to verify if the board is working, but this board requires a microUSB cable. The FTDI Cable is well protected against the elements, but is large and cannot be embedded into a project as easily. The FTDI Basic uses DTR to cause a hardware reset where the FTDI cable uses the RTS signal.
This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). We made some little change with silk-screen, it needs to connect "TX" to "TX"; "RX" to "RX" in programming, Our Arduino Pro and LilyPad boards use this type of connector.